background image

Page 2 of 8

 

Jiffy Niche

TM

 SERIES NICHES 

IS0608UA_Rev B

 

IMPORTANT SAFETY INSTRUCTIONS 

Before installing or servicing this electrical equipment, turn power supply OFF. 

 

 

 

WARNING

 

– Read and follow all instructions in this 

owner’s manual and on the equipment.  Failure to follow 
instructions can cause severe injury and/or death. 

 
 

 

Basic safety precautions should always be followed, including the following: Failure to follow instructions may result in injury. 
 

  This is the safety-alert symbol. When you see this symbol in this manual, look for one of the following signal words. And, 

be alert to the potential for personal injury. 
 

 

WARNING

 warns about hazards that 

could

cause serious personal injury, death or major property damage and, if 

ignored, presents a potential hazard. 
 

 

CAUTION

 

warns about hazards that 

will

 or 

can

 cause minor or moderate personal injury and/or property damage 

and, if ignored, presents a potential hazard.  It can also make consumers aware of actions that are unpredictable and unsafe. 
 
The NOTICE label indicates special instructions that are important but not related to hazards. 

 

WARNING –

 

This product should be installed and serviced only by a qualified professional. 

 

CAUTION –

 

All electrical wiring MUST be in conformance with all applicable local codes, regulations, and the 

National Electric Code (NEC). 

 

Use of non-Hayward replacement parts voids warranty. 

 
ATTENTION INSTALLER – THIS MANUAL CONTAINS IMPORTANT INFORMATION ABOUT THE INSTALLATION, 
OPERATION, AND SAFE USE OF THIS NICHE, THAT MUST BE FURNISHED TO THE END USER OF THIS 
PRODUCT.  FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS COULD RESULT IN SERIOUS INJURY. 

 

 

WARNING –

 Risk of Electric Shock.

  

Hazardous voltage can shock, burn, and cause 

severe injury and/or death.  All electrical wiring MUST be in conformance with all applicable local c
regulations, and the National Electric Code (NEC). 

 

 

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 

 

odes, 

 

WARNING –

 To reduce the risk of electric shock replace damaged wiring immediately.  

Locate conduit to prevent abuse from lawn mowers, hedge trimmers and other equipment. 

 

WARNING –

 It is recommended to install a Ground Fault Circuit Interrupter (GFCI) in the 

circuit, however, all electrical wiring MUST be in conformance with all applicable local codes, regulations, and the National Electric 
Code (NEC). 

 

WARNING –

 All electrical wiring MUST be in conformance with all applicable local codes, regulations, and the 

National Electric Code (NEC).  Ground and bond ALL niches before connecting lighting to electrical power supply.  Failure to ground 
and bond niches can cause serious or fatal electrical shock hazard.  Do NOT ground to a gas supply line. 

Содержание Jiffy Niche









Отзывы: