USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Page 12 of 36
2.70 THP VS Pump Family
IS3206VSP3 Rev-A
4.13.
Interface Wall Mounting
The interface can also be wall mounted using the parts supplied in the optional wall mount kit using the following
procedure.
1.
TURN OFF THE ELECTRICAL POWER AT THE CIRCUIT BREAKER.
2.
Loosen the two screws securing the user interface to the motor drive and remove the user interface.
(Figure)
3.
Disconnect the short cable that extends out from the motor drive to the user interface. (Figure)
4.
Loosen the three screws securing the wiring compartment cover to the motor drive and remove the cover to gain
access to the drive wiring compartment.
5.
Unplug the short cable from the RS485 terminal block on the low voltage PCB.
6.
Mount the wall mount plate, SP3200DR10, in the desired location. (Figure 4.13-4)
7.
diagram shown in section 5.4 to the second motor drive RS485 terminal block and user interface PCB. Use multi-
conductor, jacketed cable suitable for the installation location. The cable must be routed through one of the left
side conduit openings on the motor drive and through the slot provided on the backside of the wall mount plate,
SP3200DR10. Use a liquid tight cordgrip, appropriately sized for the cable being used, to seal the conduit
opening. Cable used may be up to 500 feet in length. (Figure 4.13-4)
8.
Mount the user interface to the wall mount plate, SP3200DR10, using the two screws. (Figure 4.13-4)
9.
Reinstall the wiring compartment cover, taking care to make sure it is properly aligned with the motor drive, and
tighten the three screws to secure.
10.
Install the blank cover, SP3200DR9, on the motor drive in the desired orientation. This cover is important to
protect internal electronics. (Figure 4.13-3)
11.
Apply power to the system and resume normal operation.
The following diagrams illustrate the interface wall mounting procedure.
Figure 4.13-1: Removing the Digital Control Interface for Wall Mounting
