Hayward ColorLogic, Руководство пользователя

Страница: 4 / 12

Installation Steps
1. Remove existing light fixture from niche
With power off at the circuit breaker, carefully remove the existing light fixture from the pool
light niche and place it on the pool deck. There should be enough power cord length to reach
the deck. If the power cord is too short to reach the pool deck surface, the light fixture should
be reinstalled with the proper length cord by a qualified individual before attempting to install
the new lamp.
2. Remove glass lens
Refer to the manufacturer’s owner’s manual for lamp removal instructions. Typically, screws
and/or a clamp fastens the cover plate and lens to the housing. Loosen fasteners and carefully
remove the lens and gasket from the light fixture.
3. Inspect fixture and remove old lamp
While the fixture is out of the pool and the lens is off, inspect the housing for wear or damage.
Do not install the BPCUS11120 into a fixture that may be prone to failure. Inspect the rubber
seal where the power cord enters the housing for leaks or deterioration. Check the surface
where the lens and gasket seats for warping or dents. Replace the tensioning clamp or other
fasteners if worn or damaged. After inspection, unscrew the old lamp and remove.
4. Clean lens and install the BPCUS11120
Make sure the inside of the light housing is completely dry. Take this opportunity to clean both
sides of the glass lens. Remove any gasket residue from the lens. Wipe completely dry. Carefully
screw the BPCUS11120 into the lamp socket.
cover plate and lens
gasket
light fixture removed from niche
power cord
BPCUS11120 LED
replacement lamp
3
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS