ASSEMBLY INSTRUCTION
SKU#60/590
NOTE:
Please consult a qualified electrician if you are not certain of the installation.
CAUTION:
Before starting the installation, disconnect the power by turning off the circuit breaker or by
removing the fuse at the fuse box.
1.
Attach the Mounting Strap (b. mounting ring) to Outlet Box using Outlet Box Screws provided.
2.
a. Screw Loop into Nipple of the fixture (can’t see in the drawing).
3.
a. Using a pair of pliers, twist open the link at one end of the Chain. Hook it to the Loop and close the link.
4.
Screw the Tube into the Bushing A as drawn. Place the top of the Decorative Strips over the Nipple A and secure
with the Cap Nuts provided. Place the bottom of the Decorative Strips over the Screws of the fixture (can’t see
in the drawing) and fasten it by using the Lock Nuts B provided.
5.
a. Weave fixture wires up through Chain, through Ring, through Canopy, through the Nipple of Mounting
Strap and put back into Outlet Box.
6.
Connect wires white to white and black to black. Cover the connections using the Wire Connectors provided.
Tie the ground wire from Outlet Box and from fixture to the Ground Screw on the Mounting Strap.
7.
a. Using a pair of pliers, twist open the link at the other end of the Chain. Hook the whole fixture to the Screw
Collar Loop and close the link.
8.
a. Place the Canopy over the Outlet Box. Tighten the Ring onto the Screw Collar Loop until the Canopy is held
firmly against the Ceiling.
9.
b. Place the Canopy to the Outlet Box by aligning the protruding Mounting Screws all the way through the
Canopy and tighten the fixture using Lock Nuts A provided. Fasten the fixture until it is firmly held.
10.
Install the bulbs. (Not included) Unscrew the Finial from Nipple . Screw the Nipple into the Bushing B and
fasten it by using the Hex Nut. Attach the Glass Shade, Washer, and secure with Finial.
11.
Turn on the power.
A S
A Satco Product
