10/08
Model HWCT8
Page 3 of 7
INSTALLATION PROCEDURE …
Step 1:
Provide wall opening as detailed in Installation Drawing. Frame must be positioned
such that frame flanges overlap and butt against finished wall surface. Mounting
holes are provided for #6 sheet metal screws. After frame is positioned in wall, swing
chiller support tray into position (see Installation Drawing), align tray holes with holes
in frame and fasten with #10 sheet metal screws. Mounted frame must support 50-
pound chiller in addition to fountain weight and user generated forces.
Note:
Trap will not fit directly below fountain receptor. Drain-waste-vent trap (by
others) must be installed, per local codes, to the side of wheelchair access area.
Service access to trap must be provided.
Step 2:
Install waste, supply and electrical lines in locations shown in Installation Drawing.
Waste and supply lines maybe installed for either rear or side entry. Verify proper
waste, supply, electrical and frame locations. Use level to verify horizontal and
vertical frame mounting to insure proper bowl drainage.
Step 3:
Unpack fountain bowl, tilt bowl and insert into frame (see Installation Drawing),
placing waste end behind lower frame crosspiece. Hook top flange of bowl behind
top frame flange and swing bowl into position with studs projecting through slots in
lower frame crosspiece. Fasten in position with two hand-tightened 10-24 UNC wing
nuts.
Step 4:
Remove bowl waste slip joint nut and install the 1-1/4” O.D. waste elbow between
waste outlet and trap, cutting to length if required. Tighten slip joint nuts.
Step 5:
See Figure 2 for detail section view of side screw grille attachment. Unpack grille and
insert lower lip behind bowl, align sides and hold up flush to bottom of top of bowl.
Hold grille against wall and mark centers of grille side slots on wall. Masking tape
may be used to prevent finished wall damage from mark. Install the “s” clips in
mounting frame using #10 sheet metal screws into pre-drilled holes on lower end of
each side of frame. Tighten #10 screws while holding “s” clips centered on wall
marks. Check grille fit by installing grille and partially tightening # 6-32 socket head
screws through side of grille.
FIGURE 1