21
4. Transportation
a. Switch the product off and disconnect from power supply before transporting it anywhere.
b. Protect the product against scratching and secure it to avoid damage from impact.
5. After use
a. Switch the product off, disconnect it from the power supply and let it cool down.
b. Fold the cutting blade align to the shaft. .
c. Check, clean and store the product as described below.
TROUBLE SHOOTING
Use this section to help you to try and solve any problems you may have:
PROBLEM
POSSIBLE CAUSES
REMIDIES
Device does not start
1. Mains voltage not on
2. On/Off switch defective
3. Worn carbon brushes
4. Defective motor
1. Check plug socket, cable, line
and plug, where appropriate,
have repaired through electrical
specialist
Device runs with
interruptions
1. Power cable is damaged
2. Internal loose electrical
Connection
3. On/Off switch defective
1. Check the cable and have it
changed by the Service Centre if
necessary
Blades become hot
1. Blades are blunt
2. Blades are notched
3. Too much friction due to lack of
lubrication
1. Have the blades sharpened or
replaced
2. Have the blades sharpened or
replaced
3. Oil the blades
NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR PRODUCT, PLEASE DO NOT ATTEMPT
TO OPEN OR REPAIR THE PRODUCT YOURSELF. DOING SO MAY VOID THE WARRANTY
AND COULD CAUSE DAMAGE OR PERSONAL INJURY. IF THE PROBLEM STILL PERSISTS,
PLEASE CONTACT US BY REFERRING TO THE SERVICE & SUPPORT INFORMATION ON THE
FOLLOWING PAGE.
