15
c. Assembly of the front handle
1) Attach the front handle to the block (A) on the lower handle
and insert the bolt. Tighten the knob to the bolt.
2) Adjust the front handle forward or backwards to a proper
position.
The dismantling takes place in reverse order.
2. Operation
Warning! Do not use the equipment without the
hand guard. Wear suitable clothing and work
gloves when working with the equipment.
Ensure that the equipment is functional before
each use. The On/Off switch and the safety
switch must not be held closed. They must
switch off the motor when on is released. Should
a switch be damaged, stop working with the
equipment. Ensure that the mains voltage value
matches the label on the equipment.
Note noise protection and local specifications.
The use of the equipment on certain days (e.g.
Sundays and national holidays), at certain times
of day (lunch times, night time quiet periods) or
in special areas (e.g. health resorts, clinics etc.)
is restricted or forbidden.
a. Swiveling out the blade beam
1) Hold the safety blade beam on the handle to adjust the
blade beam.
2) Unlock the safety lever and keep it pressed.
3) By simultaneously exerting pressure on the lock lever, you
will loosen the fixation of the cutter bar.
4) The safety blade beam can now be swiveled out. Use the
stop stages and allow the stop lever to click back in. You can
choose 12 stop stages.
5) Then, release the safety lever again and ensure that it
latches back into its initial position.
1
2
3
1
2
3
