Hawk Ghost HD16, Инструкция по эксплуатации, Страница: 11 / 20

VIDEO MODE SETTINGS:
• Video Size – Choose from 640x480 [lower] resolution or 1280x720 [higher] resolution.
• Video Length – Length of video recorded with each trigger event.
Dynamic Video - Default ‘Off’. Dynamic Video setting will override manual ‘Video Length’ setting and will continue recording
video for entire period motion is detected in video range. If you desire Dynamic Video, turn ‘On’. CAUTION: DYNAMIC VIDEO
CAN GREATLY REDUCE BATTERY POWER DURING SITUATIONS WITH A LOT OF ACTIVITY RECORDING.
• Delay Interval – Time allowed between each camera trigger event. A higher delay interval is used to limit excessive videos of
same animals in each event in motion detection range; especially, for example, in stationary feeding locations. A lower delay
interval is used to gather as many videos as possible in each event in motion detection range; especially, for example, in quick
activity situations like on animal trails or during fast pace rut activity. TIP: WHEN IN VIDEO MODE FOR QUICK ACTIVITY
SITUATIONS, IT MAY BE BETTER TO USE A LONGER VIDEO LENGTH INSTEAD OF SHORT INTERVALS, AS STORING VIDEOS LEADS TO
LONGER ‘CAMERA RECOVERY TIME’ THAN STORING PHOTOS.
• Time Stamp – Default ‘On’. This is the information bar that appears on the bottom of every video.
• Sync Coordinate – Default ‘Off’. Turn ‘On’ to store GPS location information to be saved in video properties and will allow you
to see where your camera is positioned or photo is taken via Geotag photos online ( www.geoimgr.com ) advanced searching and
sorting options.
• Field Scan – Default ‘Off’. Allows camera to take Video every so many minutes between two different times
• Select Scan Interval – Amount of time in between each Video
•
Select Start Time for Scan A
•
Select End Time for Scan A
•
Select Start Time for Scan B
•
Select End Time for Scan B
•
Select Save
**MAKE SURE TO SELECT ‘SAVE’ AFTER CHANGING FIELD SCAN SETTINGS
• Default Set – Resets All Camera Settings back to Original Manufacturer Default Settings
• Camera Mode – Default operation ‘24HRS’. Can also choose between ‘Day Only’ or ‘Night Only’ camera operation.
• Sensor Level – Default ‘Auto’. Selecting ‘High’ will result in more sensitivity in motion detection and could result in more trigger
events. Selecting ‘Low’ will reduce sensitivity to motion detection and could result in less trigger events. Auto is most common –
‘High’ or ‘Low’ use in extreme temperature or motion environments – reference troubleshooting for examples.
SETUP AND USE
03-2018 – 00 Page 10
QUESTIONS? Call 810-626-3026 or Visit www.hawkhunting.com
ADVANCED VIDEO SETTINGS
FOR MODELS 3750, 3571:
ADVANCED VIDEO SETTINGS FOR MODEL 3755: