■
Fastening pins and bushings
■
Electrical cables
Unpacking
1. Remove each hydraulic locking unit from the package separately:
■
Hold by the rod ends.
2. Remove the packaging without scratching the piston rods.
3. Check the hydraulic locking unit for completeness and transport
damage:
■
If you discover damage, refuse the delivery or accept it with
reservation.
■
Note the transport damage on the transport documents or on
the forwarder’s delivery note.
4. Dispose of the hydraulic locking unit’s packaging in a manner that complies with local regulations.
DAMAGE
For any defect found, le a complaint immediately with:
HAWE Micro Fluid GmbH
Borsigstraße 11
93092 Barbing, Germany
Tel.: +49 89 379100-6000
Claims for damage compensation can only be enforced during the applicable notification periods. HAWE
will not accept any liability for retrospective claims.
4.3 Storage
DAMAGE
Property damage from incorrect storage
Incorrect storage can lead to damage. Refer to the technical data.
Store the locking unit and its individual components as follows:
■
In disassembled state: Store only with the piston rod extended by 5 to 10 mm.
■
In installed state: Do not lock the restraint system against the locking direction.
■
Store in a dry and dust-free place.
■
Protect from sunlight (UV radiation) and corrosion (such as very salty water).
■
Protect from mechanical damage and damp.
■
Do not store near ignition and heat sources.
■
Note all additional specifications by the ride manufacturer.
20/63
B 6052-21 -
11
-2021 - 1.7
HAWE Hydraulik SE
