Havso Carolina 1.1, Инструкция по эксплуатации

Страница: 12 / 20

12
Contents and assembly
Please read through the entire user manual before you start assembling and
deciding where to put your infrared heater. Read the instructions carefully to
make sure that the infrared heater is installed, used and maintained correct-
ly, as described in these instructions. Keep the user manual for future refe-
rence.
Package contents
• 1 st. Infrared heater
• 1 st. Universal bracket, small
• 1 st. Universal bracket, large
• 1 st. Rubber plate
• 2 st. Adjustment screws
• 2 st. Long wing screws
• 2 st. Short wing screws
• 4 st. Nylon washers
Montering
1. The back of the brackets is pliable and flexible to make it easy to
install the heater. Look at the following pages when deciding where to
put your heater.
2. When you have selected the location and the universal bracket you
are going to use, adapt the rubber plate to the universal bracket by
cutting it to size and then putting it on the inside of the universal
bracket. Make sure that you do not cover any of the holes that you
need to use for the wing nuts. This prevents damage and rust, and
also ensures that the heater is firmly attached to the tube/beam. See
figure 1.
3. Attach the universal bracket to the infrared heater using the adjust-
ment screws. See figure 1.
4. You can then hang the infrared heater on the tube/beam that you
have chosen.