- 32 -
- 33 -
EN
EN
Installation/Operation/Disassembly
06 Installation/Operation/Disassembly
After the charging port is connected with the charger, connect the power adapter to wall plug. The red
indicator light will be on when it is charging, and the green indicator light will be on when battery is fully
charged.
(Figure 6-27)
Step 8
NOTE:
1.
Do not heat up the battery or put it in fire. Do not store the battery in a high temperature environment.
2.
Do not reverse the polarity when installing the battery.
3.
Do not short-circuit the battery by using any metal objects such as wire directly.
4.
Do not drive a nail into the battery, strike it by hammer, stamp or hit it by any other means.
5.
Do not disassemble or modify the battery.
6.
Do not immerse the battery in water or get it wet when storing it away.
7.
Use a lithium battery charger for charging, and do not charge the battery under 0
o
C.
8.
When not in use for a long period of time, the battery must be charged and discharged at about every 2 months.
Troubleshooting/Maintenance
07 Troubleshooting
08 Maintenance
If the bubbles continue to emerge when the product is immersed in water, there is a problem with the seal, and
you should do the following:
•
Dry the product and remove the head cover. Check the sealing ring for foreign bodies and remove them.
•
Check the sealing ring for damage and replace it if necessary.
•
Apply appropiriate amount of vaseline to the sealing ring evenly.
•
Put the head cover back and test the seal until they are no more bubbles coming.
•
The power display and the green light don't turn on when you press the switch. Check whether the battery connectors
and make sure the battery is properly connected with the product. If the light does not turn on after a proper connection,
contact the after-sales service.
•
The red light flashes when you press the switch. In this case, recharge the battery or replace it with a new one.
•
The power display works normally when you press the power switch, and the motor does not run when you press the
speed control switch. In this case, contact the after-sales service team.
•
The battery runtime decreases significantly after repeated use. In this case, replace it with a new battery.
Cannot get it running (fail to start): Check the propeller for foreign bodies and remove them.
1.
2.
1.
After use in sea water, rinse the machine with clean water (including the switches, the fast-dismantle buttons, the lock
latches of the head cover, the fuselage surface, etc.) and dry out the product.
2.
Apply appropiriate amount of vaseline to the sealing ring evenly.