- 26 -
- 27 -
EN
EN
Installation/Operation/Disassembly
06 Installation/Operation/Disassembly
Put the battery into the battery compartment and connect the cables. (Figure 6-7, Figure 6-8)
Step 4
Figure 6-4
Figure 6-5
Figure 6-6
Figure 6-7
Figure 6-8
Figure 6-9
Figure 6-10
NOTE:
1. Do not carry and pull battery cable.(Figure 6-9)
2. Please install the battery in the same way as shown in the picture. (Figure 6-7,
Figure 6-8) The outgoing line should be on the right of the battery compartment.
3. In order to power the device, please be sure to connect the male and female
connectors properly as indicated. (Figure 6-10)
Installation/Operation/Disassembly
06 Installation/Operation/Disassembly
Figure 6-11
Figure 6-12
Figure 6-14
Figure 6-13
Figure 6-15
(Optional) Place the optional clump weight on the top of the battery. (Figure 6-11)
(Optional) Place both red sealing rings in the grooves at the
base of the head cover. (Figure 6-12)
Step 5
Step 6
Lock the lock latches on both sides of the cover. (Figure 6-14)
Step 8
Tighten the vent plug clockwise with the allen wrench. (Figure
6-15)
Step 9
Please apply a generous amount of Vaseline at the base of
the head cover. Apply firm and downward pressure ensuring
a full and complete seal. Please be advised you must observe
the inside of the head cover to identify correct positioning prior
to attempting to seal the battery compartment with the head
cover. (Figure 6-13)
Step 7
NOTE:
The clump weight makes it easier to maneuver into a deep dive if installed.
NOTE:
Apply appropriate amount of Vaseline to the plug to ensure the seal.