P-MID-1^MFK-5_INST_9-07
serrated nuts.
•
Press partition as far forward and mark mounting holes where driver side mounting
bracket and “C-pillar” come in contact.
•
Pre-drill 3/16” holes into “C-pillar”.
•
Attach bracket to C-pillar using (3) ¼” x 1” Hex head lag bolts.
•
Plastic trim panel must be notched around bracket to mount.
3. ATTACH PASSENGER SIDE MOUNTING BRACEKT:
•
Press partition as far forward as
possible and holding bracket to
partition (square tubing section)
determine where to slot headliner to
accept mounting bracket.
•
Slot headliner and position mounting
bracket to be flush with vehicle inner
roof support.
•
Mark (3) mounting holes and pre-
drill using 3/16” drill bit.
•
Attach bracket to vehicle using (3)
¼” x 1” Hex head lag bolts.
•
Press partition up to bracket and
mark holes where bracket and
partition come together.
•
Drill 5/16” holes on these marks and
bolt partition to bracket using 5/16-
18 x 2” Hex head bolt, washer, and
nylock nut.
4. ATTACH UPPER STEEL CENTER FILLER PANEL:
•
Attach upper center filler to partition through the holes pre-drilled at subassembly
using ¼-20 x ¾” Carriage bolts and serrated nuts.
•
Tighten all hardware.
Passenger side upper
mounting bracket
5/16-18 x 2”
Hex head bolt
Slot in headliner
Upper Center Filler Panel
