Havahart Custom-Shape Wireless Dog Fence 5144G-A, Инструкция по эксплуатации

Страница: 10 / 33

6.
Repeat these steps to install the rest of the Bases in the
remaining 3 corners of your home.
7.
Touch the screen of the Controller to turn it on and press
“Get Started”. (See Figure 1.2)
Attaching Base using the adhesive tape:
s
Clean surface with isopropyl rubbing alcohol, wipe gently, let dry.
DO NOT USE household cleaners.
s Separate strips (if still connected) at the perforation.
s Peel the back from one piece of tape and attach it vertically to the
middle of the Controller with the tab pointed upward toward the
antennas.
s Connect the fasteners (Velcro-like teeth) on the tape of the
Controller to the fasteners on the other piece of tape. The tab
on the other piece of tape should point downward away from the
antennas -- the opposite direction of the tab on the piece of tape
on the Controller.
s Peel the back from the other piece of tape and attach it to the wall
with pull-tab facing downward toward the floor and the Controller
antennas facing upward toward the ceiling.
To remove the adhesive tape:
s Peel the Controller gently from the
wall. DO NOT pull the fasteners off the
Controller or the wall.
s Start with the piece of tape on the wall.
To prevent the fastener from snapping
your fingers, press one hand on the end
of the tape opposite the tab and use your
other hand to pull the tab of the tape
slowly down straight against the
surface of the wall stretching the tab
at least 12 inches until the strip releases.
Repeat for the tape attached to the
Controller.
Havahart
®
Custom-Shape Wireless Dog Fence
8
Figure 1.2
Figure 1.3
Activating the Bases:
1.
Once all Bases are installed, plugged in and displaying a green
power light, stand within 10 feet of the Master Base and press the
“Complete” Button on the Controller. This will activate all the
Bases simultaneously. (See Figure 1.3)
If successful, a positive auditory tone will sound and the Controller will indicate
you are now ready to proceed to setup your fence boundary. (See Figure 1.4)
If you are unsuccessful, a negative auditory tone will sound and the Controller
will advise you to re-check each Base to ensure that it is properly installed,
plugged in and displaying a green power light. (See Figure 1.5)
Figure 1.4
Figure 1.5
Installing the Custom-Shape Wireless Dog Fence -
Setting Up the Bases