A
OPERATING INSTRUCTIONS
19
Figure J
Figure K
Figure L
2. Line feeding (See fig M)
Your trimmer uses 0.065” (1.65mm) diameter,
round nylon line to cut grass and weeds
quickly and easily. During use, the tip of the
nylon line will get shorter due to wear. Gently
bump the unit on the ground and the line will
feed out. Cutting line will wear faster and
require more feeding if the cutting or edging
is done along sidewalks or other abrasive
surfaces or heavier weeds are being cut.
Figure M
3. CLEARING JAMS AND TANGLED LINES
From time to time, especially when cutting
thick or stalky weeds, the line feeding spool
head may become clogged with sap or other
material and the line will become jammed as a
result. To clear the jam, follow the steps listed
below.
1) Unplug the trimmer.
2) Press the release tabs on the spool head
cover, as shown in Fig P and remove cover by
pulling it straight off.
3) Lift the spool of nylon line out of the spool
head as shown in Fig Q and clear any broken
line or cutting debris from the spool area. (If
you plan to replace the spool or rewind it, this
is the place to do so, otherwise, move on.)
4) Unwrap about one foot (30cm) of line to
ensure that it’s undamaged. If it is OK rewind
it and insert the line end through the eyelet in
the spool head. Ensure the spring is in place
under the spool. Pull the line through the hole
to maintain tension while placing the spool
down into the spool head with the arrow up as
shown in Fig Q.
5) Locate the spool place it on the head
retainer. (Locate the spring centrally) Take
care to keep the line from becoming trapped
under the spool.
6) Snap the spool head cover back on and at
the same time pull the line and be sure that
it is released from spool rail notches. If not,
the bump-feed feature can not operate. Hold
the tool in the trimming position and turn the
tool on. In few seconds or less, you’ll hear the
nylon line being cut to proper length. If not,
bump the feed head gently on the ground to
initiate a fresh length of line.
Содержание 8401022
Страница 23: ...23 A ...
Страница 24: ...F CONSIGNES D UTILISATION 24 10 ...