Haussmann 59595069, Руководство оператора

Страница: 9 / 25

ENGLIS
H
OPERaTION
WaRNING! Before connecting your power tool to power supply, always
check to be sure switch is not in lock-on position. Failure to do so could
result in accidental starting of your power tool.
VaRIaBLE SPEED CONTROLLED TRIGGER SWITCH
Your tool is equipped with a variable speed trigger switch. The tool can
be turned "ON" or "OFF" by squeezing or releasing the trigger.
The speed can be adjusted from the minimum to maximum nameplate
RPM by adjusting the variable speed knob (3) or the pressure you
apply to the trigger (4). Apply more pressure to increase the speed and
release pressure to decrease speed .
2.LOCK-ON FEaTURE
Your grinder has a lock-on feature that is convenient when continuous
operation for extended periods of time is required. To lock-on, depress
the trigger switch(4), push in the lock-on button (5) located on the side
of the handle, then while holding the lock button pushed in, and release
the trigger.
To release the lock, depress the trigger switch and release it.
3.REVERSING SWITCH LEVER
The reversing lever (2) is located above the trigger switch and is used
to reverse rotation of the drill bit. The reversing switch should only
be activated when the motor is “OFF” and when bit is at a complete
standstill (Fig. 1).
To use tool in “Forward” rotation move lever to left side of tool, to
“Reverse” the rotation of the bit move the lever to the right side of the
tool.
4.STaRTING THE HOLE
Using a slow speed will enable you to start the hole accurately in most
cases without the need for center punching.
5.DRILL BITS
Always inspect drill bits for excessive wear. Use only bits that are sharp
and in good condition.
TWIST BITS: Available with straight and reduced shanks for wood and
light duty metal drilling. High speed bits cut faster and last longer on
hard materials.
CARBIDE TIPPED BITS: Used for drilling stone, concrete, plaster,
cement and other unusually hard nonmetals. Use continuous heavy
feed pressure when using carbide tip bits
Before using an accessory, be certain that its maximum safe operating
speed is not exceeded by the nameplate speed of the tool. Do not
8