Haussmann Xpert 68125026, Руководство оператора

Страница: 18 / 19

PNT131
ENGLISH
18
MAINTENANCE & STORAGE
STORAGE
If it is necessary to store the tool for an extended period of time, apply a generous
amount of lubrication before storing. The tool should be run for approximately 30
seconds in order to ensure that the lubrication is evenly distributed throughout the tool.
The tool should be stored in a clean and dry environment.
TROUBLESHOOTING
!
!
WARNING: If any of the following symptoms appears while operating the tool, stop
using the tool immediately, or serious personal injury could result. Only an authorized
service centre should perform repairs on this tool. Disconnect the electrical plug and
disconnect any tools from air supply before attempting any adjustment.
NOTE: Troubleshooting problems may have similar causes and solutions.
SYMPTOM PROBABLE CAUSE CORRECTIVE ACTION
The tool runs at normal
speed, but loses power
under load.

Motor parts are worn.

The cam clutch is worn or
sticking due to insufficient
lubrication.

Lubricate the clutch housing.

Check for excess clutch oil. Clutch cases should only be
filled halfway. Overfilling may cause drag on high-speed
clutch parts. A typical oiled/lubricated wrench requires
1/2 oz (15 ml) of oil.
GREASE/LUBRICATION NOTE: Heat usually indicates
insufficient grease in the chamber. Harsh operating
conditions may require more frequent lubrication.
The tool runs slowly. The
air flows slightly from the
exhaust.

Dirt particles have gotten
jammed in the motor.

The power regulator is in
the closed position.

The air flow is blocked by
dirt.

Check the air inlet filter for blockage.

Pour air tool lubricating oil into the air inlet, as per
instructions.

Operate the tool in short bursts, quickly reversing
rotation back and forth, where applicable.

Repeat above as needed.
SERVICE
INTERVAL
Lubricate the tool

If the tool is used without an in-line lubricant then be sure
Cleaning

Wipe tool clean and inspect tool for wear or damage.
Use non-flammable cleaning solutions to wipe the tool.
Never soak the tool in these solutions as they can
cause internal damage.
Tighten Screws

Always ensure that all of the screws are kept tight as
loose screws can cause injury or can damage the tool.
MAINTENANCE TASK DESCRIPTION /REASON
to put in about 3 drops of lubricant at the start of each
workday and 3 drops and each 30 minutes of use
thereafter.
Daily & every
30 minutes of
use thereafter
Each use
Check each
usage.
Tighten as
necessary.