Haussmann Xpert 68125026, Руководство оператора

Страница: 15 / 19

15
ENGLISH
IMPORTANT SAFETY INSTRUCTIONS FOR AIR-POWERED CAULKING GUN
GENERAL SAFETY INSTRUCTIONS
!
!
SERVICE

Tool service must be performed only by qualified repair personnel.

When servicing a tool, use only identical replacement parts. Use only
authorized parts.

Use only the lubricants supplied with the tool and specified by the
manufacturer.
AIR SUPPLY AND CONNECTIONS

The air supply connection must not hold pressure when air supply is
disconnected. If an incorrect fitting is used, the tool can remain charged with air
after disconnecting and thus will be able to work even after the air line is
disconnected, possibly causing injury.

Do not use any type of reactive gases, including, but not limited to, oxygen and
combustible gases, as a power source. Use filtered, lubricated, regulated
compressed air only. Use of a reactive gas instead of compressed air may
cause the tool to explode which will cause death or serious personal injury.

Use only a pressure-regulated compressed air source to limit the air pressure
supplied to the tool. The regulated pressure must not exceed 100 PSI. If the
regulator fails, the pressure delivered to the tool must not exceed 200 PSI. The
tool could explode which will cause death or serious personal injury.

Always disconnect air supply from tool:
a) before making adjustments.
b) when servicing the tool.
c) when clearing a jam.
d) when tool is not in use.
e) when moving to a different work area, as accidental actuation may occur,
causing injury.

Never use oxygen or any other combustible bottled gas as a power source as
this could cause explosion and serious personal injury (see Fig 1).

Disconnect tool from air supply hose before performing any tool maintenance
and during non-operation. For emergency stops and prevention of unintended
operation, a ball valve near the gun air supply is recommended.

Use clean, dry and regulated compressed air rated at 40 to 60 PSI, never
exceed the maximum allowed operating pressure of 90 PSI.

Before operating the tool, make sure all the screws & caps are securely
tightened to prevent leakage.

Never modify this tool for any other applications. Only use parts, nozzles and
accessories recommended by manufacturer.
WARNING:
Tool generates very high pressure on grease, tubes and fittings. A
leak could cause grease to penetrate skin resulting in severe injury or amputation.
WARNING:
Before operation, inspect tool and attachments to ensure they have
not been damaged and are properly assembled.
Fig.1