General Operating Rules
1. Inspections as stated above must be made prior to each use of the Swivel Hook
2. Before each use make sure the Swivel Hook is properly installed on the fork tines and that the
hook is secured to the Swivel Hook frame and the bolt is tight.
3. Determine that the load your lifting is within the capabilities of the Swivel Jib and the capacity
of the Lift Truck. Never exceed the capacities on either the Forklift or the attachment, Remember
that capacity of the Forklift decreases when the load is raised and especially with Telehandlers when
the load is extended.
4. Before picking up a load make sure that it is balanced and level. Make sure that the slings, straps or
any other rigging is properly secured and is not twisted or entangled in anyway.
5. Do not pull loads. The Swivel Jib is designed for vertical lifting ONLY.
6. Carry all loads low and use tag lines to keep loads from swinging.
7. Be sure forklift is on a level /firm surface before raising the load.
8. Forks should always be level or slightly tilted back, never tilted forward when using the Swivel Jib.
9. The Forklift operator must remain in the seat at the controls with the engine running whenever there
is a load on the Swivel Jib.
10. Only qualified and trained personal should operate the forklift. Operators should know and follow
all local, state and federal safety regulations
11. All safety regulations must be followed at all times.
12. Any personal working around the Swivel Jib must wear hard hats and steel toed boots
13. When lifting loads there should be no personel within a minimum of ten feet in all directions of the
fall zone, never put yourself or any part of your body under a suspened load.
14. Do not use the Swivel Jib in anyway to lift personal.
15. Refer to the Forklift’s operators manual for more information on handling elevated loads and
additional safety tips.
Marv Haugen Enterprises
1851 Heartland Ave. - Casselton, ND 58012
Toll Free 877-580-6218
Phone: 701-347-4827 Fax: 701-347-4830
