Hatteland JH 10T06 MMD, Руководство пользователя

Страница: 31 / 84

1
INB100005-1 (Rev 19)
IND100133-1
Connection area of display (illustration)
TOUCHSCREEN / VGA OUT: (optional)
Connect the RS-232 cable to the D-SUB 9P Connector (female) on the rear side of the TFT display.
Connect the other end to your COM port of your computer. Install the nesscessary software to operate it.
- Note that the connector is only installed upon customer request. VGA OUT connector is then removed.
- By factory standards the product have been mounted with a VGA OUT 15PIN DSUB connector, this signal
is a clone of the incoming signal.
COMPOSITE IN (PAL/NTSC/SECAM VIDEO):
Connect your composite video signal cable into the RCA jack plug. To activate the Picture In Picture
function, the TFT display must be configured via the OSD menus.
- Note that Composite Video must be selected as the incoming video source in the OSD menu.
S-VIDEO IN:
Connect your S-Video (SVHS) video signal cable into the mini 4-way din plug. It can only be inserted
one way and make sure you don’t bend any of the pins inside your cable. To activate the Picture In Picture
function, the TFT display must be configured via the OSD menus.
- Note that
S-Video must be selected as the incoming video source in the OSD menu.
RGB IN:
Connect the VGA cable to the D-SUB 15P Connector (female) on the rear side of the TFT display.
If possible, screw the VGA cable to the D-SUB connector and make sure you don’t bend any of the pins
inside the VGA cable connector. To reduce tension of the VGA cable, secure it to the base mounted cable
tie clamp. Connect the other end of the cable to the VGA output of your computer, and fasten it there also.
RGB Out or Touch
(Optional)
Composite In
S-Video In
RGB IN
Power Input Serial Interface(opt)
Physical Connections - MMD/STD Models
DVI-D IN (newer models)
NOTE: Available connectors/locations may vary depending on model !