Hatco STM-4G Series, Инструкция по установке и эксплуатации, Страница: 7 / 24

Form No. STMSM-1007
5
INSTALLATION
PLUMBING
Water Auto Fill (Recommended for Commercial Use)
The unit is equipped with an Auto Fill feature that
eliminates having to manually fill the water tank.
To use the Auto Fill feature, the valve located at the
rear of the unit must be connected to the closest tap
water supply using the connector pipe included with
the unit.
NOTE: For commercial use, it is recommended to
install the supplied water filter in the water line to
prevent scale buildup.
1. Connect 6 mm (.25") plastic tubing to the inlet
side of the Everpure™ IN-10 water treatment
filter supplied.
2. Connect another piece of 6 mm (.25") tubing
from the outlet of the filter to the inlet water fitting
on the back of the steamer.
UNPACKING
The Electric Steamer is shipped with most
components installed and ready for operation. The
following installation instructions must be performed
before plugging in and operating the unit.
1. Remove unit and information packet from box.
2. Remove all contents from inside the unit.
3. Remove tape and protective film from all
surfaces of unit and contents.
LOCATION
Transport the unit to a suitable location and place on
a flat, level surface.
WARNING
The unit must be transported in an upright
position. The water must be drained from the
unit. Failure to do so may result in damage to the
unit or personal injury.
CAUTION
To avoid any injury or damage locate the unit at
the proper counter height, in an area that is
convenient for use. The location should be level
to prevent the unit or its contents from
accidentally falling, and strong enough to
support the weight of the unit and contents.
WARNING
This appliance is not suitable or designed for
operation on ships, airplanes, tourism cars, or
similar locations. A qualified electrician must
evaluate the risk of operation to avoid personal
injury or damage to the appliance.
CAUTION
To avoid injury or damage to the unit DO NOT
move or relocate the unit while it contains any
food product or water in the tank.
CAUTION
Do not place anything on top of the unit; doing
so could damage the unit or subject personnel
to possible injury.
CAUTION
Unit is not weatherproof. For safe and proper
operation the unit must be located indoors
where the ambient air temperature is a minimum
of 21°C (70°F) and a maximum of 29°C (85°F).