Hatco PW Series, Инструкция по установке и эксплуатации

Страница: 7 / 24

7 Form No. PWM-0721
English
OPERATION
General
Use the following procedures to operate the Plate Warmer.
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
Startup
1. Move the Power I/O (on/off) switch to the
I
(on) position.
CAUTION
BURN HAZARD: Some exterior surfaces on the unit will
get hot. Use caution when touching these areas.
2. Allow 60 minutes to preheat the unit.
NOTE: The digital temperature controller is preset to a setpoint
temperature of 104°F (40°C) at the factory. Once the
setpoint temperature is changed, the new setpoint
temperature will remain in memory until it is changed
again. The minimum to maximum setpoint temperature
range is 104°F (40°C) to 122°F (50°C).
Shutdown
1. Move the Power I/O (on/off) switch to the
O
(off) position.
2. Unplug the power cord/turn off power at circuit breaker
and allow the unit to cool before performing any cleaning
or maintenance.
Changing the Setpoint Temperature
Use the following procedure to change the setpoint temperature.
1. Press the
key one time.
• The icon will flash on the screen.
2. Press the key or key within 5 seconds to change
the setpoint temperature.
3. Wait 10 seconds to save the new setpoint temperature.
Digital
Temperature
Control
Power I/O (on/off)
Switch
Controls
Set Key Down Key Up Key Power I/O Switch
Control Panel