General
The Mini Display Warmer is shipped with most
components installed and ready for operation. The
following installation instructions must be performed
before plugging in and operating the unit.
FIRE HAZARD: Locate the unit a minimum of 1″
(25 mm) from combustible walls and materials. If
safe distances are not maintained, combustion
or discoloration could occur.
Unit is not weatherproof. Locate the unit indoors
where the ambient air temperature is a minimum
of 70°F (21°C) and a maximum of 85°F (29°C).
Locate the unit at the proper counter height in an
area that is convenient for use. The location
should be level to prevent the unit or its contents
from falling accidentally and strong enough to
support the weight of the unit and contents.
Do not lay unit on the side with the control panel
or damage to the unit could occur.
1. Remove unit from box.
2. Remove the information packet.
NOTE: To prevent delay in obtaining warranty
coverage, fill out and mail in the warranty
card to Hatco.
3. Remove tape and protective film from all
surfaces of unit.
4. The stainless steel floor in all units is protected
during shipping with a sheet of corrugated
cardboard. This protection must be removed
prior to cabinet operation.
5. The shelves have packing material and
cardboard attached for protection during
shipping. This protection must be removed prior
to cabinet operation.
6. Position the shelves at adequate heights to
accommodate your product. The shelves may
be inserted horizontally or inclined with the
product stops toward the service area access
(see Figure 5).
7. If the unit is equipped with an optional
Merchandising Display Cover, see the
Accessories section for installation instructions.
NOTE: The unit must be transported in the upright
position. If laid on its side, all glass surfaces
must be secured with tape.
NOTICE
CAUTION
WARNING
Product Stop
Magnet
Shelves may be
inserted horizontally
or inclined.
INSTALLATION
4
Form No. MDWM-0608
Figure 5. Shelves
All manuals and user guides at all-guides.com
all-guides.com
