Hatco HWB-11QT, Инструкция по установке и эксплуатации

Страница: 3 / 28

Form No. HWBM-0107
1
IMPORTANT SAFETY INFORMATION
IMPORTANT! Read the following important safety information to avoid personal injury or
death, and to avoid damage to the equipment or property.
WARNINGS
To prevent electrical shock or injury, turn the
power switch OFF, disconnect the unit from
the power source and allow to cool before
performing any maintenance.
The Built-In Heated Wells are not waterproof.
To avoid electrical shock or personal injury,
DO NOT submerge in water. Do not operate if
it has been submerged in water.
Risk of fire, install Built-In Heated Well a
minimum of 3-1/2" (89 mm) from bottom of
appliance to all combustible surfaces to
assure safe and proper operation.
To avoid any injury or damage, Hatco
mounting kits must be used when mounting
unit in a combustible countertop.
To assure proper and safe operation the
remote control panel with thermostat control
must have at least a 6" (152 mm) clearance
from the Built-In Heated Well.
For proper and safe operation the remote
control panel location must be mounted on a
vertical wall.
Some exterior surfaces on the unit will get
hot. Use caution when touching these areas
to avoid injury.
To avoid injury or damage to the unit, do not
use harsh chemicals such as bleach or
cleaners containing bleach, oven cleaners,
or flammable cleaning solutions to clean the
Built-In Heated Wells.
The drain water may reach temperatures in
excess of 200°F (93°C). To avoid any injury or
damage to the unit use appropriate plumbing
materials when installing drain.
To avoid any injury or damage to the unit
turn unit off when filling with water and avoid
splashing.
Do not use Heated Well to melt or hold ice.
Doing so may cause condensation, an
electrical hazard, personnel injury, or
damage to the unit. Damage caused by
condensation is not covered by warranty.
To avoid personal injury or damage to
equipment, the Built-In Heated Wells must be
installed by qualified, trained installers.
Installation must conform to all local
electrical and plumbing codes. Check with
your local plumbing and electrical inspectors
for proper procedures and codes.
Hatco Corporation is not responsible for the
actual food product serving temperature. It is
the responsibility of the user to assure that
the food product is held and served at a safe
temperature.
If service is required on this unit, contact
your Authorized Hatco Service Agent, or
contact the Hatco Service Department at
800-558-0607 or 414-671-6350; fax 800-690-
2966 or International fax 414-671-3976.
This product has no “user” serviceable
parts. To avoid damage to the unit or injury
to personnel, use only Authorized Hatco
Service Agents and Genuine Hatco
Replacement Parts when service is required.
Genuine Hatco Replacement Parts are
specified to operate safely in the
environments in which they are used. Some
aftermarket or generic replacement parts do
not have the characteristics that will allow
them to operate safely in Hatco equipment. It
is essential to use Hatco Replacement Parts
when repairing Hatco equipment. Failure to
use Hatco Replacement Parts may subject
operators of the equipment to hazardous
electrical voltage, resulting in electrical
shock or burn.