OPERATION
Form No. GR2S2BWm-0511
11
General
Use the following procedures to operate Glo-Ray
Designer
Heated Shelves and Buffet Warmers.
Read all safety messages in the IMPORTANT SAFETy
INFORMATION section before operating this equipment.
BuRN HAzARD: Some exterior surfaces on unit will get
hot. use caution when touching these areas.
Startup
1. Plug unit into a properly grounded electrical receptacle of
the correct voltage, size, and plug configuration. See the
SPECIFICaTIONS section for details.
GR2S Model
1. move the Power ON/OFF (I/O) switch to the ON (I) position.
The Indicator Light will light up when the unit is energized.
2. Turn the BaSE heat control to the desired setting between
LOW and HIGH.
3. allow the unit 15–20 minutes to reach operating
temperature.
Figure 8. Controls for GR2S and GR2BW
WARNING
CAUTION
Power ON/OFF
(I/O) Switch
Indicator
Light
BASE Heat
Control
GR2BW Models
1. move the Power ON/OFF (I/O) switch to the ON (I) position.
• The Indicator Light will light up.
• The overhead heating element and display lights will
energize.
2. Turn the BaSE heat control to the desired setting between
LOW and HIGH.
3. If equipped, turn the TOP HEaT CONTROL to the desired
setting.
4. allow unit 15-20 minutes to reach operating temperature.
Figure 9. Controls for GR2BW with Optional Top Heat Control
Shutdown
1. move the Power ON/OFF (I/O) toggle switch to the OFF (O)
position.
• GR2S models: The heated base will shut off.
• GR2BW models: The heated base, overhead heating
element, and overhead display lights will shut off.
Power ON/OFF
(I/O) Switch
Indicator
Light
BASE Heat
Control
TOP HEAT
CONTROL
