INSERT 3 AA BATTERIES
1. INSERT THE BATTERIES
To insert the batteries, make sure the red ON/OFF
switch is OFF. Then loosen the screw on the battery
box, located on the underside of the center module,
and remove the door. Insert three AA-size alkaline
batteries, making sure to align the + and – symbols
with the markings in the plastic. Then replace
the door and tighten the screw. Phillips/cross
head screwdriver (not included) needed to
insert batteries.
IMPORTANT: BATTERY INFORMATION
CAUTION:
1. TO AVOID BATTERY LEAKAGE
a. Always follow the instructions carefully.
Use only batteries specified and be sure to
insert them correctly by matching the + and –
polarity markings.
b. Do not mix old batteries and new batteries or
standard (carbon-zinc) with alkaline batteries.
c. Remove exhausted or dead batteries from
the product.
d. Remove batteries if product is not to be played
with for a long time.
e. Do not short-circuit the supply terminals.
f. RECHARGEABLE BATTERIES: Do not mix these
with any other types of batteries. Always remove
from the product before recharging. Recharge
batteries under adult supervision. DO NOT
RECHARGE OTHER TYPES OF BATTERIES.
2. Should this product cause, or be affected by,
local electrical interference, move it away from
other electrical equipment. Reset (switching off
and back on again or removing and re-inserting
batteries) if necessary.
2. ASSEMBLE THE GAME UNIT
Apply the green Advanced
Weapons label to the side of the
center module with the red
ON/OFF switch. Apply the red
label to the other side.
Apply the large green
BATTLESHIP label and two
rubber feet to the back of the
green battle grid. Apply the large
red BATTLESHIP label and two
rubber feet to the back of the red
battle grid.
Press the battle grid panels
into the sides of the module,
with the green grid on the side
with the red ON/OFF switch.
Snap the target grid into the top,
with the green side facing the red
ON/OFF switch.
Apply the storage tray labels to
both tray lids.
3. PLACE THE GAME PARTS
IN THE TRAY
Carefully detach the 10 combat
crafts from the plastic frames,
and then discard or recycle
the frame. Assemble each tank
by inserting the peg on the
underside of the gun turret into
the body. Use an emery board
or sandpaper to remove excess
plastic from the ships.
Remove all pegs from the bags.
Place half of the parts in each
storage tray, so that each
tray has:
• 34 red HIT pegs
• 64 white MISS pegs
• 10 blue SCAN pegs
ON/OFF
SWITCH
RED LABEL
2X
GREEN LABEL
CENTER MODULE
ON/OFF
SWITCH
STORAGE TRAY LABEL
THE FIRST TIME YOU PLAY
GAME CONTENTS
• Four-piece folding game unit with tray lids
• 5 gray combat crafts
• 5 red combat crafts
• Red, white, and blue pegs
• Label sheet
• 4 rubber feet
OBJECT
Destroy your opponent’s fleet of ships
before yours is destroyed!
QUICK START
To get into the game fast!
5
GAME GUIDE CONTENTS
The First Time You Play
3
Crafts and Setup
4
Quick Start
5
The Games
Solo Classic Battleship
6
2 - Player Classic Battleship
7
2 - Player Advanced Battleship
8
Automatic Fleet Layouts
10
2
3
RED BATTLE
GRID
TARGET
GRID
GREEN BATTLE GRID
(X2)
INTRODUCTION
A38461050 I Battleship Elec.indd 2-3
1/11/17 12:10 PM
