IS-36 Issue: 3 Date: 27.04.2022 C/Order: 31490
Page 3 of 7
Rotate the locator down, snapping the lower tabs on the locator
into the bottom slots on the tool.
Correct position for the
locator.
WIRE PREPARATION
1.
Ensure that the wire to be crimped is within the specified range of sizes for the contact and
the crimp tool. Failure to use the specified wire size will result in poor quality crimps and
possible tool damage.
2.
Cut the end of the cable to be terminated so that there is a clean cut end (Figure A). Strip
the cable to the correct length (Figure B). We recommend that when the wire is stripped, it
is clamped or supported close to the stripping area - this will prevent insulation slippage.
Suitable wire strippers (such as a PTFE wire stripper) must be used. This should result in all
the strands lying together neatly. If the lay of the strands is disturbed, it may be re-
imposed with a slight twist.
Clean cut
Ø1.10mm max
RIGHT
WRONG
2.70 – 3.00mm
Figure A
Figure B
CRIMPING PROCEDURE
1.
Ensure that the crimp
tool is at the fully
open position.
2.
Push the button on the back of the locator, which will
move the locator forward between the crimp dies.
