HARVEY HPS1600E, Оригинальное руководство пользователя

Страница: 14 / 62

- 13 -
7. MOVE THE RIP FENCE.
Move the rip fence out of the way when crosscutting;
8. DIRECTION OF FEED.
Feed work into the blade against the direction of rotation;
9. NEVER.
Never use the fence as a cut-off gauge when you are cross-cutting;
10. NEVER.
Never attempt to free a stalled saw blade without first turning the saw OFF;
11. PROVIDE ADEQUATE SUPPORT.
To the rear and sides of the table saw for wide or long work pieces;
12. AVOID KICKBACKS.
Avoid kickbacks (work thrown back towards you) by keeping the blade sharp, by keeping the
rip fence parallel to the saw blade, by keeping the splitter and anti-kickback fingers and guard in
place and operating, by not releasing work before it is pushed all the way past the saw blade, and
by not ripping work that is twisted or warped or does not have a straight edge to guide along the
fence;
13. AVOID AWKWARD OPERATIONS.
Avoid awkward operations and hand positions where a sudden slip could cause your hand to
move into the spinning blade;
14. BLADE REQUIREMENTS.
Only correctly sharpened saw blades manufactured in accordance with the requirements of
EN 847-1:2005 shall be used;
15. SPEED.
No saw blade shall be used where the maximum marked speed is lower than the maximum
rotational speed of the saw spindle;
16. CHIP AND DUST.
The machine shall be connected to an external chip and dust extraction system;
The dust extraction equipment is to be switched on before commencing machining;
17. CHECK
Period check the brake function to make sure the stop time of the saw blade is less than 10s.
If more than 10s, maintenance the brake according to chapter 8;
4.3 Residual risks
1. Take precautions to reduce the hazard of inhalation of harmful dusts (e.g. wearing a dust
mask);
2. Wear ear protection to prevent hearing loss;
3. Always wear safety glasses. also use a face or dust mask if cutting operation is dusty;
4. Against the hazard of cutting when handling saw blades into the machine or doing
maintenance;
5. Not to try removing chips whilst the saw blade(s) is (are) running and the saw unit(s) is (are)
not in the rest position;
6. Not to try using the machine unless all of the guards and other safety devices necessary for
machining are in good working order;