Page
33
of
34
Harvest
by Meridian
H10XX
Assembly
Manual
Step 54
Next, install the upper transition flighting (30864) on the the lower drive shaft attached to the swing tube
flighting. To do this, slide a 3/8” x 1” square key into key way on swing tube flighting shaft. Slide upper
transition flighting onto shaft aligning the key and keyway. To secure the transition flighting thread the set
screw that is 5/16” x 1-1/4” into hole on knuckle (Fig. 54.1). After set screw is tightend, thread a 5/16” flange
nut onto set screw and tighten to lock set screw in place.
Step 55
Next, install the swing hopper onto the swing tube. Slide the hopper transition onto the swing tube while
inserting the square shaft of the upper transition flighting into the square tube on the lower transition flighting.
Align the holes in the hopper and swing tube with a punch. With the access door open secure the hopper to the
swing tube using (2) 1/2" x 1-1/2” flange bolts, (4) 1/2" washers, & (2) 1/2" top lock nuts. The washer will go
between the bolt and the hopper & the nut and swing tube respectivly.
Fig. 54.1
Fig. 55.1