15
Diagnostics
After pushing the DIAGNOSTICS key in the Main Menu screen, the following screen should appear:
The diagnostic mode will automatically check the pump output and performance of the three pumps. It is
recommended to use this mode daily to ensure proper system performance.
Round Balers
Pump
Low Tips Output
(Lbs / HR)
High Tips Output
(Lbs / HR)
1
38
– 53
64
– 88
2
76
– 105
119
– 165
3
115 - 160
225
– 312
Small Square Balers
Pump
Low Tips Output
(Lbs / HR)
High Tips Output
(Lbs / HR)
1
21
– 30
34
– 47
2
64
– 88
64
– 88
3
123
– 170
175
– 240
1. Once the screen is displayed, press the PUMP OUTPUTS key. The machine will cycle all three of the
pumps for 15 seconds. After the cycles are complete, the system will display results next to each pump.
2. If the system displays within the listed range.
A. The system is operating correctly.
If
the system displays higher than the listed range, some common problems could be:
A. Leak in line, tip missing, tip worn, and high tractor voltage.
If the system displays lower than the listed range, some common problems could be:
A. Make sure there is preservative in the tank and ball valve is in the open position.
B. Air in lines. Pump will not prime. Check for leak in lines, or defective check valve.
C. Pump is working, but not producing desired output. Pump needs to be rebuilt.
D. Main filter plugged. Check filter by tank and clean if necessary.
E. Tip or tip screen plugged. Check both tip and tip screen and clean if necessary.
F. Kink in hose. Straighten or replace hose.
G. Voltage from tractor is low. Check power cord with multimeter for 12 volts at baler mounted
processor. Clean connections on battery. Dielectric grease connections at baler mounted
processor and at hitch connection.
H. Pump is defective. Rebuild pump if motor runs smoothly. Replace pump if motor is bad.
I. Defective flow meter. Only if all pumps run, product is applied, and all numbers read 0.
3. To set date and time, press the SET DATE/TIME key. In the next screen enter the date (month, day,
year format) followed by the time. When done press the ENTER key. NOTE: Clock uses military time.
4. The voltage should be between 12.0 to 14.5 volts for the system to work properly. If voltage is not in
this range check all power cord connections and the tractors charging system.
5. When done in this mode, press the MAIN MENU key.
1
5
4
2
3
