HARTMANN TRESORE
5
• Check the safe for any defects and make sure all the accessories included
are complete before putting it into operation.
• The safe must be screwed securely to a surface. The fixing material is included
with the delivery.
• Insert the batteries supplied into the battery compartment. The battery compartment
is on the rear of the door.
•
“Good”
appears on the display, meaning that the system is in start mode.
• Once
“Okay”
appears, the safe is ready to use.
• If no further action is performed after a key operation, all previously performed actions
are deleted after a few seconds/minutes and the initial state is restored.
• Incorrect inputs can be corrected using the
“clear”
key.
PLEASE NOTE!
Optionally, 4 different I-buttons can be used. Their functions are described in chapter 7.
To obtain I-buttons, please contact Hartmann Tresore.
The safe requires a basic setting so that a code can be assigned to the I-button sup-
plied. Depending on which type of I-button it is, this code can vary. It must be assigned
to the safe as follows: Hold the I-button against the receiver.
An audible signal (beep) confirms that the owner’s I-button has been assigned.
The Smart Safe System, whose function is described in Chapter 8, can also be optio-
nally used to read out operations. To purchase the Smart Safe System, please contact
Hartmann Tresore.
3 | PUTTING INTO OPERATION
!
