Hartke HA5500, Руководство пользователя

Страница: 8 / 20

6
Guided Tour - HA5500 Rear Panel
Hartke Systems
Distributed Exclusively by
Samson Technologies Corp.
Hicksville, New York 11802
MODEL 5500
350 WATTS
8 = 350 WATTS
4 = 500 WATTS
CAUTION
TO PREVENT SHOCK, DO NOT OPEN. NO USER
SERVICEABLE PARTS INSIDE. REFER SERVIC-
ING TO QUALIFIED SERVICE PERSONNEL. TO
PREVENT FIRE OR SHOCK HAZARD, DO NOT
EXPOSE TO RAIN OR MOISTURE.
ASSEMBLED
IN R.O.K.
SERIAL NUMBER
EFFECT
SEND
RETURN BALANCE
DIRECT OUT
0
SEND RETURN
POST
PRE
NORMAL
GND LIFT
~ AC INPUT
115V/230V 50/60Hz
FUSE
10A/250V, 300W (115V)
6.2A/250V, 740W (230V)
2
1 4
3 5 8 9
3 6 7 10
SPEAKER
OUTPUTS
8
Ω
8
Ω
1. Fuse sled - This contains a fuse holder and shows the currently selected
voltage rating for your Model 5500. Make sure the voltage rating is correctly set
before powering up the amplifier! Fuse ratings are 10 amp for 115 vac and 6.2
amp for 230 vac. For information on how to change the voltage rating, see
Appendix C on page 18.
2. AC input - Connect the supplied standard 3-pin “IEC” plug here.
3. Speaker outputs - Connect any 4, 8, or 16 ohm bass cabinet(s) to these
standard unbalanced 1/4” jacks. WARNING: Because of the high power lev-
els and low frequency content of the signal generated by the Model 5500, use
only appropriately rated speaker cabinets (at least 600 watts at 4 ohms) that are
specifically designed for bass instruments. We recommend that Hartke ampli-
fiers be used with Hartke bass cabinets, although other brands of speakers can
be used.
4. Fan - The fan provides vital cooling to your Model 5500. Make sure that it is
kept free of all obstructions and that cool, fresh air is accessible at all times.
Also, try to ensure that the Model 5500 is used in a dust-free environment.