5 – English
OPERATION
APPLICATIONS
You may use this product for the following purpose:
Light-duty vacuuming of dry surfaces
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 7.
Insert the battery pack into the battery port as shown.
Make sure the latch on the battery pack snaps into place
and the battery pack is secured in the product before
beginning operation.
Depress the latch and pull to release and remove the
battery pack.
For complete charging instructions, see the operator’s
manuals for your battery pack and charger.
STARTING/STOPPING THE VACUUM
See Figure 2, page 7.
To start the vacuum:
slide the ON/OFF switch toward
the front of the vacuum.
To stop the vacuum:
slide the ON/OFF switch toward
the back of the vacuum.
CREVICE TOOL
See Figure 3, page 7.
Turn off the vacuum.
Remove the battery pack.
Flip the crevice tool forward.
Slide the crevice tool into the dust bowl so that it stays
in place during use.
When not in use, pull the crevice tool out and flip it back
up into place for storage.
REMOVING/REATTACHING THE DUST BOWL
See Figures 4 - 5, page 7.
The dust bowl should be checked, emptied, and cleaned
periodically for maximum dust collection.
To remove:
Remove the battery pack.
Depress the release button located on top of the hand
vac. Pull the dust bowl down and out.
To reattach:
Position the two sections as shown. Align the slot on the
bottom of dust bowl with the tab on the bottom of motor
housing, then snap the two sections together.
MAINTENANCE
This product contains no serviceable parts.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
CLEANING/REPLACING THE FILTER
See Figure 6, page 7.
Remove the battery pack and the dust bowl.
Remove the filter by pressing the tabs inward and lifting
the filter out of the screen assembly.
Shake or lightly brush any dust or dirt off the filter.
Remove the screen assembly from the dust bowl.
Shake or lightly brush any dust off the screen and screen
assembly. Wash if necessary.
Empty the dust bowl; wash if necessary. Before
reattaching to the hand vac, make sure all pieces are
completely dry.
When purchasing replacement filter, request recommended
part number
533907002.
NOTE: ILLUSTRATIONS START ON PAGE 7
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
