9 – English
NOTICE:
This product is designed to be powered by either a
HART 20V battery pack (DC mode) or by electric power
(AC mode). The power mode is selected by sliding the
power selection door to the desired power source and
either installing an approved battery pack or extension
cord as described in this manual.
APPLICATIONS
You may use this product for the purposes listed below:
Clearing leaves and other debris from your lawn
Keeping decks and driveways free from grass clippings,
leaves, pine needles, and other debris
INSTALLING/REMOVING BATTERY PACK
See Figure 3.
Slide power selection door over power receptacle until it
clicks into place.
Insert the battery pack into the product as shown.
WARNING:
Make sure the latches on the battery pack snap in place
and the battery pack is fully seated and secure in the
blower battery port before beginning operation. Failure
to securely seat the battery pack could cause the bat-
tery pack to fall out, resulting in serious personal injury.
Depress the latch to release and remove the battery pack.
For complete charging instructions, see the operator’s
manuals for your battery pack and charger.
WARNING:
Always remove the battery pack or disconnect the tool
from the power supply and keep hands clear of the
power switch when carrying, transporting, assembling
parts, making adjustments, cleaning, or when not in
use. Following these instructions will prevent acciden
-
tal starting that could cause serious personal injury.
STARTING/STOPPING THE BLOWER (DC)
See Figures 3 - 4.
Slide power selection door over power receptacle until it
clicks into place.
Insert battery.
To start the blower, place the power switch in the
ON ( l )
position.
To stop the blower, place the power switch in the
OFF
( O )
position.
STARTING/STOPPING THE BLOWER (AC)
See Figures 4 - 6.
Remove battery pack from the blower if installed.
Slide power selection door over battery port until it clicks
into place.
Route an extension cord loop through the slot located
at the bottom of the blower and wrap through the cord
retainer.
NOTICE:
Always use cord retainer to properly attach extension
cord to the blower. Failure to use cord retainer may
result in damage to the blower and/or extension cord.
Attach the outlet end of an extension cord to the plug on
the rear of the the blower.
NOTE:
Use only approved outdoor extension cords.
To start the blower, place the power switch in the
ON ( l )
position.
To stop the blower, place the power switch in the
OFF
( O )
position.
OPERATING THE BLOWER
See Figure 7.
To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the center
of a pile.
To reduce sound levels, limit the number of pieces of
equipment used at any one time.
Use rakes and brooms to loosen debris before blowing.
In dusty conditions, slightly dampen surfaces when water
is available.
OPERATION
