FBL-545/654/655/644/645/646/656
3G Aluminium Weighted Portagoal
Code:
Product:
7
Attach the First Net Bar Bracket
- Remove the Hand tight Binx Nuts, position one Net Bar Bracket and re-fit nuts (do this at one end
only).
(Supplied Separately)
6
Assemble the Roller
- Fit one end of the Axle bar to a Side Bar as follows: Position a Collar in between the Axle Bracket Lugs on one
of the Side Bar Assemblies and Insert the Axle Bar. Lock the end in place with an 80mm Bolt and Nut. Slide on a Plastic Axle Bush
inserted into the ends of each Roller Tube, slide over the open end of the Axle Bar. Repeat for the other Rollers until you reach the middle
where a slim axle bush will be required, slide this onto the axle bar before sliding the remaining rollers on. If Ballast Tubes are supplied
with your goal, fit these now into the Axle and secure the Axle in place using the Collar and Bolts. Using a mallet, fit the End Caps into the
ends on the Axle.
The Backbar acts as a Roller so that the Goal can be
by handles.
Lift both handles at the same time and roll the goal into position.
manoeuvred
Operating Instructions
1
2
Identify the edge to be fitted to the Crossbar, this will be marked with a label. Attach the hooks to the net, then insert the hook into the
slot on the goal section and twist to lock. Space each net hook approx 250mm apart. Tie the headline to the top corner of the Net
Support to stop the roof of the net from sagging.
Attach the net at the bottom by threading the bar through alternative meshes on the last row of the net. Insert the bar into the bracket and
secure as described in step 7.
Fitting The Net
Assembled Detail
Whole Goal
Fig 6 Exploded
Fig 7 Exploded
Assembled Detail
Fig 8 Exploded
Assembled Detail
18
13
28
3
21
27
8
10
8a
6
Ballast
(inside)
(if applicable)
If supplied, fit 8a
(longer roller) at
each end.
22
25
