Chapter 2
Installation
12
Copyright © 2003, 2005-2006, 2010, Harris Corporation
Setting
HSD6800
+
Jumpers
The HSD6800
+
module has one standard jumper, J3, which determines the slew
rate control. Follow this procedure to set the jumper.
1
Locate jumper set on the module.
Figure 2-1
shows the standard location of
the jumper set. Pin 1 is identified by a small white triangle printed on the
module.
Figure 2-1
Location of the HSD6800
+
Jumper Set
NOTE
: If both HD and SD signals are to be passed through the distribution
amplifier module, choose the jumper setting for the HD slew rate (pins 2
and 3).
2
Place a jumper on the pins that correspond to the slew rate that you want. See
Figure 2-2
.
Figure 2-2
HSD6800
+
Jumper Set Settings
For SD slew rates, set the jumper to pins 1 and 2.
For HD slew rates, set the jumper to pins 2 and 3.
