175-100067-00 Edition A (December 2008)
1
Copyright © 2008, Harris Corporation
Preliminary—Contents are proprietary and confidential. Do not photocopy or distribute.
CCS-NET-24 Initial Setup Guide
Overview
The out-of-box configuration of the Extreme Networks Summit
®
X250e
1
(P/N
CCS-NET-24) is sufficient to support a small (up to 24 devices), stand-alone,
single-switch network of Harris router and router control products.
Configuration
No specific configuration steps are required to enable basic operation.
Establishing IP Configuration and Enabling Remote
Management Interfaces
If remote management via Telnet, web-based interface or Extreme Networks
management software is desired, the following steps should be followed to establish a
basic IP configuration and enable the remote management interfaces:
1. Unpack the switch.
2. Connect the switch to power using its supplied power cable.
3. Connect the null modem cable supplied with the switch to a the RS-232 port of the
PC.
4. Launch the PC’s terminal application (such as HyperTerminal), and then create a
serial terminal session with the following settings:
• 9600 baud rate
• 8 data bits
• 1 stop bit
• No parity
5. Press the
Enter
key on the PC to cause the switch’s login prompt to display.
6. At the login prompt enter
admin
.
1
"Summit" is a registered trademark of Extreme Networks
©
of Santa Clara, California.
