Harris AES-3981, Инструкция по установке и эксплуатации

Страница: 38 / 56

26 AES-3981 Installation and Operation Manual
Preliminary—Contents are proprietary and confidential. Do not photocopy or distribute.
Chapter 3: Operation
4. Press Select to activate the selection.
Restoring Default Settings
To restore the alarms to their default settings, follow these steps:
1. Select
Alarms , select Config , then press Select .
2. Scroll down the list of alarms, then select Reset
.
3. Press Select to activate the selection.
Table 3-2 lists the default alarm settings for the AES-3981. You can
enable or disable these settings, but you cannot change the level of the
alarm.
State Recovery Parameter Availability
The parameter settings for this module are automatically saved onto the
AES-3981 resource module installed in your NEO frame every five
minutes. If a module should fail and be replaced with a cold spare, the
state parameters can be automatically recovered. For more information
on this feature, see the
NEO FR-3901, FR-3903, and FR-3923
Mounting Frames Installation and Operation Manual (Edition E and
above).
Table 3-2. Default AES-3981 Alarms
Card-Edge ID Alarm Name Alarm Level Description
+3.3V Alrm +3.3V power alarm Major +3.3 volts out of
range
+5V_Alarm +5V power alarm Major +5 volts out of range
–5V Alarm -5V power alarm Major –5 volts out of range
AES_Error AES error Minor AES error detect
BM_Type Back module type Minor Back module type
detection
Sig_Pres Signal presence Minor Signal presence
detect