Harper Goossen 1300, Руководство оператора

Страница: 12 / 44

Harper/Goossen
10
3. Connect the cables to the proper
terminals, connecting the UNGROUNDED
cable first. Do not over tighten. Apply a
commercial battery anti-corrosion material
or petroleum jelly to the terminals, to
minimize corrosion.
FUEL TANK
SAFETY WARNING!
Gasoline is extremely flammable and can
be highly explosive.
•
Make sure the vent valve on the gas cap
is open. (If the cap is closed the engine
will vapor lock and will not run.)
1600 and 1800 models only
PTO Powered Model
1. Connect the PTO shaft to the jackshaft of
the Straw Blower.
2. Install the pins provided and connect your
three point hitch to the Straw Blower.
IMPORTANT: Do not connect the PTO
shaft at this time.
3. Raise the Straw Blower to the height
where the PTO shaft would be level if
installed (shortest length).
4. Hold the PTO shaft yoke level with the
540 output shaft of the tractor.
5. Allow for ¾” clearance between the outer
shield and the bell housing at the Straw
Blower end of the PTO shaft.
6. If the PTO shaft is too long, separate the
halves and cut the full amount of excess
length from both the male and female half.
Note: If you cut only one end of the drive
shaft, the other end will bottom out during
operation. Cut the inner and outer shields as
necessary to compensate for the length
adjustment.
7. Connect the yoke of the PTO shaft to the
540 output shaft of the tractor.