Harper 14A01, Руководство оператора и каталог запасных частей

Страница: 12 / 56

Turbo Vac TV60R
Specific Safety Guidelines
Set-Up and Operation
TV60RH
• Avoid wearing loose clothing to pre-
vent it from getting caught in the PTO
drive.
• Keep clothing and all body parts away
from rotating parts.
• The pump stop bar must be properly
positioned to keep the hydraulic pump
from spinning with the PTO.
• The Turbo Vac hydraulic system oper-
ates under high pressure. Be sure the
hydraulic system is disabled prior to
service.
SAFETY WARNING!
Engage the tractor PTO at low engine
RPM when operating the TV60RH to
prevent premature failure of hydraulic
system components.
SAFETY WARNING!
HIGH-PRESSURE FLUID HAZARD!
Escaping fluid under pressure can
penetrate skin and cause serious injury
or death.
SAFETY WARNING!
Wear approved eye protection and safety
gear during set-up and operation of the
Turbo Vac.
TV60RH
1. Before using the TV60RH for the first
time, install the battery cable onto the
tractor battery to supply power to the
unit’s valve and RF receiver. Connect
the black wire of the cable to the
negative terminal and the red wire
(with fuse) to the positive terminal of
the battery. When using more than one
tractor, other power cords may be or-
dered (p/n 935017).
2. Attach the unit to a tractor with a PTO.
Be sure that the Turbo Vac is level with
the ground. (Refer to Adjustments
section.)
3. Slide the hydraulic gear pump onto the
PTO shaft of the tractor.
4. Fasten the torque bar or chain to the
tractor to prevent the pump from
rotating.
5. Make certain that the case drain hose
is on top of the pump and in a vertical
position when attached to the tractor.
6. Plug quick connector on battery cable
to the quick connector located on the
tongue of the
TV60RH
.
7. Engage tractor PTO and set to 540
RPM.
1210