- 7 -
V4-10-10
Assembly instructions awnings TC110 - TC120 - TC130
E2-Setting of the end switches of the motor
In principle the motor is already set at the factory, but it may
be necessary to change the setting.
For this proceed as follows:
For a LT-motor (TC110 – TC120):
First remove the yellow cap from the adjusting buttons.
Press in both buttons fully to against their stops so that they
remain a little deeper. The end settings are then fully removed in both directions.
Now allow the awning to roll out until the desired position is reached.
Note: never allow arms to go past their straightened position but stop them a little before. Then place
the switch to its neutral.
Press the white button (or yellow, depending on the building-in side) so that it rises slightly. Check the
roll-down direction of the fabric roll and establish which arrow on the motor corresponds with the
required rotational direction.
The buttons have the shape of a rounded arrow. The button, whose rounded side points at the rota-
tional direction of the fabric, is the button for adjusting that rotational direction. Push this adjusting
button once, so that it rises slightly. At that moment the roll-down direction is set.
Roll the blind up, until the extension pole touches the box.
Press the white button (or yellow, the other one, for the upper position) so that is rises slightly.
Replace the cover cap on the buttons.
The end switches of the motor are set now.
Important: If the awning unrolls too far without stopping automatically, turn the switch in the reverse
position and let the motor run for a while and then stop.
Push the corresponding adjusting button once again; in order to set the end switch to a neutral posi-
tion.
Let the motor run for a while and stop at the desired position. Push this last adjusting button once
again in order to set the new adjusting point.
Always check whether the motor is actually switched off when reaching its top position. A humming
sound after the extension pole is folded up, means that the motor is not adjusted properly. The motor
does not stop in time.
For a SLT-motor (TC130):
Remove the yellow cover cap from the buttons.
Press the buttons against their stops so that they remain a little deeper.
The end settings are fully removed in both directions.
Now allow the awning to roll out until the desired position is reached.
Note: never allow the arms to go past their straightened position but stop them a little before. Then
place the switch to its neutral position.
Press the white button (or yellow, depending on the building-in side) so that it rises slightly.
Then roll up the awning again and stop at a distance of 10 cm before the closing of the awning.
