- 5 -
V4-10-10
Assembly instructions awnings TC110 - TC120 - TC130
Once the angle is correct, both tilting mechanisms
must be securely tightened. To do this, tighten
both pointed screws ‘A’. Now, replace the covers
on the side consoles.
The TC100 adjusting mechanism will guarantee
continuous control of the awning. The system
is both accurate and simple to operate. It is
therefore essential to ensure that the awning is
perfectly horizontal. The correct setting of the
tilting mechanism will also facilitate the rest of
the assembly.
D6. Crank handle operation:
The standard operation device is a worm-screw
mechanism supplied with a transmission ratio
of 1 to 7. This mechanism requires no special
adjustment. Only a few factors must be taken into
account:
- The crank handle should be positioned as near as
possible in line with the eye-hoisting device while
turning.
- Always ensure that the fabric unwinds over the top of the roller
tube for this type of awning.
- Fully unroll the awning until the arms are almost in straight line,
at which point the arms have reached their maximum load-
bearing limit. However, if the roller tube is turned any further, the
fabric will be too slack. In that case make a few reverse turns until
the fabric is taut again.
D7. Electric motor:
For connecting or adjusting the electric motor, see point E.
Mounting type
Angle (in °)
1
0 - 38
2
38 - 76
3
14 - 52
4
52 - 90
Mounting
type
Angle
Drop
1500
2000
2500
3000
1
0
0
0
0
0
38
569
758
948
1137
2
38
569
758
948
1137
76
896
1195
1493
1792
3
14
223
298
372
447
52
728
970
1213
1455
4
52
728
970
1213
1455
90
923
1231
1539
1847
Tabel 1: Angle per mounting type
Table 2: angle in function of drop
(approaching values)
