Harol SC1000, Руководство по установке

Страница: 17 / 21

INSTALLATION INSTRUCTIONS INTEGRAL SCREEN SC1000 ENVIRO
03/15
|
17
6. ELECTRICAL CONNECTIONS
Note: The connections must be carried out by a registered installer (refer to guarantee card
2.1.) Electrical installation and connection diagrams must be applied correctly, the electrical
accessories employed must comply with the current standards and/or requirements.
6.1. Connection diagram for a single pole switch
The motor has 4 wires. Yellow-green (earth), blue (neutral), brown and black (up and down
control). There should be three wires available from the mains electricity circuit. Yellowgreen
(earth), blue (neutral) and phase. Connect the wires following the diagram. The phase wire
of the mains is to be connected to terminal L.
If required, reverse the brown and black wires from the motor in the switch so that the
arrows correspond to the up and down movement of the screen. The two earthing wires
are interconnected by means of separate terminals. The arrangement for the two neutral
wires is similar.
Connecting and installing the motor:
Feed the motor cable in a discreet manner into the control switch. Connect the motor
cable and the power supply to the single pole switch. See above. Interchange the brown
and black cable if necessary to follow the arrows on the switch. It is mandatory to use one
or more relay boxes when two or more motors are connected to a single switch. Refer to
diagram RI2 for making the connections.
yellow / green
brown / black
brown / black
red
blue
Fig.36