9
SETTING UP YOUR TA-R SHELTER
1.
Assemble all arches on the ground making sure that you follow the positions of each part has shown on
page 6
. Place the arches on
the ground has shown on
Figure
A
.
Caution: Set the first and last arch with 2 holes posts (#4-2TPVIAS004) in order to install the diagonals (#9-2TPVIAS005).
2.
Connect the base of the posts of the first arch with the base of the posts of the second arch with two swedge braces (
#10-2TENT4M
)
and secure the diagonals (
#9-2TPVIAS005
) at the base of the posts of the second arch.
3.
Lift the first arch and bolt the diagonals to the posts of the first arch.
4.
Lift the second arch and secure it to the first one by putting in place the swedge braces (
#10-2TENT4M
).
5.
To assemble the other arches, secure the base of the post of the last arch lifted with the base of the post of the next arch. Lift it and
secure them by putting in place the proper brace.
Caution: Always place the female braces (#11-2TENT4F) between the second and third arch.
Important: All the wing nuts must be tighten and placed inside the shelter in order not to touch the cover.
6.
Before putting the cover on set the frame where you want it, adjust the base width and set the frame square measuring as shown on
(
Fig. B
). The two measurements must be the same.
Caution: If the structure is not perfectly square, the cover will be difficult to install and could be damaged during the
installation
.
7.
Carefully slide the cover on top of the frame using ropes as show on (
Fig. D
).
8.
Tie the cover to the frame with the supplied rope (
Fig. C, D, E and F
). Start at the center of both ends moving towards the sides. At
the bottom, tie the cover to the base braces.
Important: The tarp must always be securely tied in order to avoid premature wear and tear.
9.
Once the tarp is installed, anchor the shelter using the nail anchors (
#18-2T3002
&
#19-1T0030
) in a “
X
” shape as shown on
page 5
10.
Install the accessories following the instructions supplied with each items.
WARNING: WE STRONGLY RECOMMEND THE USE OF ‘’WINDSECURE KIT’’ (OPTIONAL
ITEM, 2T3800-A) TO HOLD YOUR SHELTER WHEN IT IS EXPOSED TO STRONG WINDS.
(FIG.G). NEVER INSTALL A SHELTER WITHOUT USING THE APPROPRIATE ANCHORS.
FIG. A
FIG. B
FIG. C
FIG. D
FIG. G
Содержание PVI 11
Страница 1: ...PLAN D INSTALLATION ASSEMBLY PLAN MOD LE MODEL PVI 11 PVI 12...
Страница 3: ...3 LISTE DES PI CES PARTS LIST...
Страница 6: ...6 INSTALLATION DES CONTREVENTEMENTS BRACES INSTALLATION...
Страница 7: ...7 INSTALLATION DES RAIDISSEURS ET DIAGONALES STIFFINERS AND DIAGONALE INSTALLATION...
