1 8
portion
MUST NOT
be lying across the child’s stomach as this can cause major
injuries to the child in case of a sharp turn, sudden stop or crash.
!
DO NOT
allow the child to slouch, slide down in the seat, or create slack in the
belt system
(26)
. If child will not keep vehicle belt properly positioned,
DO NOT
use this booster seat.
!
The vehicle seat headrest should not create a gap between vehicle seat and
booster seat
(27)
. If so, remove the vehicle headrest.
!
DO NOT
use any load bearing contact points other than those described in the
instructions and marked in the child restraint.
IF IN DOUBT ABOUT THESE POINTS OR ANY QUESTIONS RELATED TO
INSTALLATION, PLEASE CONTACT HARMONY JUVENILE PRODUCTS.
1.
Place the booster seat flush against a forward-facing vehicle seat, centered
between the Isofix anchors. The vehicle seat
MUST
be equipped with a 3-point
lap-and-shoulder belt. Booster must be level, stable and not rock side-to-side.
2.
Locate the Isofix connectors underneath the rear of the seat backrest
(28)
. Gently
guide the Isofix connectors against the anchors, engaging the Isofix connectors
(29)
. An audible “click” will be heard when engaged and the indicator window
will turn
GREEN
(30)
.
3.
Place child in the booster seat with child’s back flat against the back of the
booster seat.
4.
Adjust headrest height (see “Adjusting headrest and harness shoulder straps”).
5.
Thread shoulder belt portion of the 3-point lap-and-shoulder belt system through
the shoulder belt guide
(31)
and ensure that shoulder belt lies across child’s
shoulder and chest, and
NOT
across child’s face or neck.
6.
Thread both sides of the lap belt over lower guides on both sides as
indicated
(31)
. ENSURE that the belt is snug across the child’s hips. It is
INSTALLING WITH (OR WITHOUT) ISOFIX SYSTEM
& V E H I C L E S E AT B E LT
i - S I Z E / S P E C I F I C V E H I C L E B O O S T E R S E AT ( 1 0 0 T O 1 5 0 C M )
WARNING!
!
DUE TO VARYING ANGLES OF VEHICLE SEAT BELT RETRACTORS,
EXCESS SLACK IN THE VEHICLE BELT SYSTEM MIGHT NOT BE REMOVED
AUTOMATICALLY.
Once the lap and shoulder portions of the seat belt are
properly positioned and the buckle is attached,
FEED ANY REMAINING
SLACK OF THE SEAT BELT MANUALLY BACK INTO THE RETRACTOR TO
TIGHTEN THE WHOLE SYSTEM.