Figure 2-1: HMC 4001 module carrier front and rear panel features
Chapter 2 Installing the SPL 7110-Exx Transmitter
Installing the Transmitter Module
© 2009 Harmonic Inc.
14
SPL 7110-Exx, Version 1.0, Rev A
To install the transmitter module in the HMC 4001 carrier:
■
Insert the transmitter into the carrier until it locks into position.
To remove the transmitter module from the HMC 4001 carrier:
■
Press down the spring-loaded tab on the carrier, then pull out the module.
To install the HMC 4001 carrier in the HLP 4200 and HLP 4800 platform:
1.
Lower the HLP 4200 platform’s control/display panel.
2.
Slide the HMC 4001 carrier into any available slot in the platform until it is properly
seated.
3.
Lock the carrier into position with the carrier locking screw, shown in Figure 2-1.
The SPL 7110-Exx receives power from the HMC 4001 carrier. The carrier is powered by the
+24 VDC bus of the HLP 4200 and HLP 4800.
For additional information on the HLP 4200 platform and HLP 4800 platform and its
associated communication and power buses, see the
HLP 4200 Instruction Manual
or the
HLP 4800 User’s Guide.