MediaDeck 7000 component replacement
23
MediaDeck Component Replacement Guide
Winking the MediaDeck
If you are using more than one MediaDeck, use the Wink function to identify the MediaDeck that contains
the module to be replaced.
When the wink state is on, the light bar on the front panel of the MediaDeck, and the status LED on the
back of the processor module will be activated.
1. Click
Monitor
>
Devices
>
MediaDeck
.
2. At the bottom of the page, click the
Wink On
button.
Winking the module
When the MediaPort or ChannelPort wink state is on, the status LED on the rear panel of the module will
be activated.
1. Click
Monitor
>
Devices
>
MediaDeck
.
2. Click the
Wink On
button at the bottom of the page.
Removing a module from the chassis
Remove the module from the chassis using a cross-head screwdriver.
1. Disconnect any cables from the module.
2. Using a screwdriver, loosen the two screws on the rear panel of the module as shown.
The screws are captive and will not come out completely.
3. Using both hands to grip the screws, gently pull out the module from the chassis, as shown in the
following figure.
2
3