SL600HD PINNACLE STAIR LIFT:
Install Manual
25MAR2022 | 75403 E
6
PREPARATION
PINNACLE HD STAIR LIFT: SECTION 3
SECTION 3
PREPARATION
Installations may vary to some degree, but below
are the basic tools to have on hand for a Pinnacle
stair lift installation.
If you have any questions, concerns or comments,
please contact our Technical Service Department at
800-833-0478 or [email protected].
REQUIRED TOOLS
•
Cordless drill
•
Allen wrenches (5/64", 5/32", 3/16", 5/16")
•
Phillips screwdriver (#3)
•
Nut driver (3/8", 5/16")
•
6" - 10" driver extension
•
Level
•
Hack saw or chop saw
•
SAE socket set
•
SAE wrenches
•
Tape measure
•
Volt meter
INCLUDED PARTS
Before beginning installation, inspect and check
the box contents and report any damage or missing
items to Harmar.
CHASSIS BOX CONTENT:
•
Chassis
•
Call / send parts
•
Two (2) call/send hand controls
•
Battery charger
•
Manual override tool
(optional)
RAIL BOX CONTENT:
•
Bottom rail pre-installed with:
−
Bottom end plate
−
Charge strip wire harness
•
Bottom limit cam
•
Joint pins and joint brackets
(two-piece rail only)
•
Plastic gear rack
•
Top rail pre-installed with charge strip wire
harness.
•
Rail accessories
(plastic bag)
with:
−
Top end plate
−
Compression bolts
(2 sizes)
−
Self-cutting screws 1/4"-20 x 1"
−
Torx T30 driver bit
−
Extra plastic racks
(2 or 3)
−
Top limit cam
RAIL BRACKET BOX:
•
Rail brackets (2, 3, 4, or 6 per set)
•
Wood screws #14 x 2" (Four (4) per rail bracket)
CHAIR AND FOOTREST BOX:
•
Chair
•
Back rest
•
Seat belt
•
Footrest complete with swivel slide rails and
swivel pin bracket
•
Rear seat support
