5
helix curved Stair lift - Installation & Service Manual 2014
Part Number: 630-00008- Rev A
Installation
harmar’s curved Stair lift is easy to install. the standard installation
will normally take only two installers approximately two hours. the
time will vary depending on the complexity of the lift ordered and
custom designs.
1. review Installation Drawing
the dimensions on the drawing
show numbers on the stairs. these numbers indicate the
position of the Supports.
2. carry chair/chassis to the location of the installation.
usually top of stairs. It's best to be a flat section of rail.
Figure 5-1
Figure 5-2
Figure 5-3
Figure 5-4
Follow the drawing included with the rail system.
Run a wire through the lower rail. there is a hole at the
charger location for it to come out.
[Figure 5-2]
6.
check both ends of the rail and wipe clean. You may
need to clean the ends with emery paper and add a
small amount of grease to help slide the pipes together.
[Figure 5-5]
3. Position Stair Supports
Place on the stair based on the installation drawing but
do not bolt anything down at this point.
[Figure 5-1]
4.
clean or tap screw threads that hold track together.
check rail inside burs powder coating.
5. assemble the rail
Place the rail in the correct position beginning with the
first section downstairs. unwrap the rail, checking the
label on the foam packaging for order of placement on
stairs.
[Figure 5-3 & 5-4]
WIrING Note:
You may complete the wiring while putting the rail
together or use a fish tape on the completed unit to run the wire.
ImPortaNt
do Not lay chair on its back.
Figure 5-5
