AL6000 / AL6000HD:
Owner’s Manual
27AUG2021 | 630-00152 REV A
10
OPERATION
AL6000 / AL6000HD: SECTION 3
SECUREMENT WITH
OPTIONAL Q’STRAINT RETRACTORS
1.
With the optional Q’Straint retractors, place
each hook in the appropriate anchor plate
slot, U-bolt, or tie-down loop. The straps will
automatically retract and secure the mobility
device. Make sure each strap retracts without
any interference or slack in the strap. Adjust
if necessary. To release, press and hold the
lever to release the straps and then remove the
hooks. See Figure 3-7.
PUSH TO
RELEASE
TURN TO
TIGHTEN
Figure 3-7
2.
Either two or four retractor configurations can
be used. For two retractor systems, one
Q’Straint should be located on each corner
opposite each other on the platform.
See Figure 3-8.
Figure 3-8
SECUREMENT WITH
OPTIONAL HOLD-DOWN ARM
1. The hold-down arm may be rotated out of the
way. Pull the T-handle and rotate the hold-
down arm to the desired position. Release the
T-handle to lock in place.
See Figure 3-9.
Figure 3-9
2.
The hold-down arm can be rotated over the
center of the seat. Pull the T-handle and rotate
the arm to the desired position. Release the
T-handle to lock in place. See Figure 3-10.
Figure 3-10
The armrest of the mobility device may have to be
raised or removed to properly position the hold-down
arm to avoid damage.
NOTICE
